![]() ![]() The 10 gpm pump is plumbed to a stack of Prince SV valves, then on to the other functions of the processor. ![]() The return from the saw motor flows directly to the tank, unfiltered. Unless I'm missing something, this would allow the cut cycle to occur with one valve handle pull. This solenoid would be activated with a switch of some sort tied to the actuation of the saw bar cylinder valve. That oil flows through a power beyond circuit to a solenoid valve for the saw motor. The 20 gpm pump is plumbed to a Prince autocycle valve for the splitter. Ps - I modified this post from the previous one, adding a different drawing schematic.Īs drawn, I have a double pump setup flowing 20 and 10 gallons per minute respectively. I hope the drawing will convey my meaning. Let me apologize in advance for the lack of proper schematic knowledge. Ok, after a PM from whitepine, I came up with this hydraulic schematic. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |